RF radiation can come through your windows. act as antennas especially if you are operating in close proximity to the antenna. USB cables, SignaLink interface cables, etc. I was subjected to this behavior in the early days of National Parks on the Air, 2016, until I realized what was going on and installed RF chokes on all of my interface cables. It is possible close proximity to the antenna can cause electromagnetic interference (EMI) problems that latches-up PSK31 software execution. This is just an idea because I am not familiar with Raspberry Pi and FLDIGI running on Rasberry PI. Thanks in advance for your consideration of this problem. Do I need additional software to run in conjunction with fldigi for rig control? Too many options listing too many unfamiliar acronyms are given. I feel that I must be doing something wrong in the Rig Control part of the fldigi setup which is very confusing to me. So the hardware at least the interface to the radio is okay. I was able to transmit with that configuration but it was inconvenient to connect, disconnect and reconnect for I use the laptop in a location across the room from the transceiver when I am not doing radio stuff. I previously tried using essentially the same setup but with a laptop running windows 10 and Digipan software. The software allows me to "Tune" and it (the software) thinks, it seems, that it is sending a tone, but the interface does not show a PTT active nor does the transceiver switch to transmit mode. But I cannot get my transmitter keyed at all. I am able to receive pretty well, in spite of having only a hamstick single band vertical whip atop my RV trailer for an antenna. I am trying to get into bpsk31 using my old Kenwood TS-141s transceiver, a Raspberry Pi computer running fldigi and a SignaLink USB interface on 20M. I am on a very limited budget and due to my full time RV lifestyle I must also keep my equipment to a minimum size and weight. I am new to the hobby and have begun to enjoy HF.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |